Home » Greenkeeping » Page 55

Category: Greenkeeping

Pre Season Mowing Program

There is more to mowing than meets the eye

Whatever the season, mowing remains the most important job in the maintenance of a Performance Bowling Green.

Often overlooked due to the everyday nature of the task, there is a lot more to mowing than meets the eye. It is particularly important to follow the correct mowing regime to ensure green consistency and speed. More detailed information on green speed and consistency here.

At this time of year in the run up to the new season, it’s especially important that we get the mowing program right.

During the winter the green surface should have been maintained at a mowing height of around 8mm. In very cold winters, you will see some recession in height and this is difficult to avoid. However, in mild winters, like the one most of us have had this year it is quite normal for the green to keep growing throughout the winter months and this growth needs to be kept in check to minimise the outbreak of diseases and other problems associated with lush winter turf.

Now that the new bowling season beckons we need to gradually lower the cutting height and I would suggest taking it down to around 7mm this month, aiming for 6mm by opening day and 5mm by the end of May, all dependent on soil temperature and prevailing weather; we can still be in the grip of icy cold winds at Easter.

Mowing frequency will be dictated largely by growth rate, but once a week now should be the minimum, bearing in mind that you don’t want to be removing more than a third of the leaf at any one time. So, if the green is growing vigorously, then more frequent mowing will be required.

Of course its tempting to keep the work to a minimum, but mowing will also help to lightly roll the green surface, so it might be beneficial to mow more frequently than is actually required.

The most important factor in mowing is ensuring that the mower is razor sharp and that there is zero contact between the blade and cylinder to give the cleanest and least damaging cut to the grass leaf. More detailed information on mowing can be found here.

Tomorrow we will look more closely at the pre-season renovation work required on the green, with a look at some do’s and don’t’s.

Dead Bees on Bowls Greens

Our email forms on the site have been playing up this week and not sending on the email addresses of people making enquiries in some cases.

One such case was an enquiry about dead bees on the green. The message read:

Over the last week I have found dozens of bees dead or dying on the greens…. has anyone else found this? and what might have caused it? it is troubling…

Well, as an amateur bee keeper this troubles me too, so any input from readers would be appreciated.

There are a few different possibilities here:

At this time of year when the bees are flat out producing and feeding new brood and storing food for later months, the worker bees only live for about 5 or 6 weeks, by which time they are worn out and die, so if there are hives fairly close to the greens this might be one explanation.

Another possibility is that the weather conditions might not have been suitable for the bees, particularly if it has been colder than normal for the time of year as it has been here in Scotland.

Then its on to more troubling causes, with the various disease and parasite problems that beset bee colonies, such as Varroa mite being uppermost here.

Pesticides are another possibility.

Beyond that there is a very troubling condition which has become known as “Colony Collapse” which has decimated honey bee populations around the world including here in the UK. A definitive cause for this hasn’t yet been identified.

It would be good to get feedback from more experienced beekeepers and anyone else who has some ideas or theories on this.

Meantime, if you are interested in learning more about the problems faced by the honey bee, then there is a very good program on the BBC iPlayer here ,which is available to watch for another 5 days.

Investing in Irrigation-can you afford not to?

Irrigation: cost or investment?

Previously we talked about some of the reasons commonly put forward for not watering bowling greens. I also shared with you, my amusement that so many clubs fail to mention irrigation or lack of it when looking for an explanation for the poor quality or condition of their greens; even though it’s very obvious. They will use just about every other aspect of bowling green maintenance as a reason for poor performance.

Now we come to the cost of irrigation; and I am not talking about the cost of installing a system, but merely the cost of the water being applied on any given night.

This is another big reason or excuse that I hear a lot about:

“we can’t water any more because it costs a fortune”

Now of course there will be variations (slight) around the country and also from system to system, but here is my 10 second rundown on the cost of water for irrigation:

  • As we saw previously a typical system will put out 1mm of irrigation water for every 2 minutes of system run time.
  • A typical system will also put out 150 litres per minute; so to calculate the cost per mm of irrigation we do this:
  • 2 (minutes) X 150 (litres) X 4 (sprinkler heads) = 1200 litres/mm

That’s to achieve 1mm over the whole green.

As 1200 litres is 1.2 m3 you simply have to multiply the irrigation requirement in millimetres by your cost per m3 and then by 1.2

Example:

  • Water balance sheet shows we need to replace 15mm of moisture loss.
  • Multiply 15 (mm) X 1.2 (m3) X £/m3
  • 1.2 (m3) X £0.90 = £1.08/mm of irrigation over entire green.

I’ve used 90p as an average cost, but you can find your own local charge on your water bill or by phoning the water company.

The question is whether you see irrigation as a cost or an investment in the future of your green.

Deal with thatch and compaction Now

Regular readers of my articles will know my views on bowling green maintenance problems; essentially there are only 2 that you have to worry about.

Everything else that goes wrong with greens is a symptom of these big 2 issues or indeed a symptom of the commonly held views on how to tackle the big 2.

What are the big 2?:

  1. Thatch: the build up of dead shoots, roots and debris on the turf surface that can get out of hand very quickly and cause or contribute to a huge number of problems. See my article on the circle of decline here
  2. Compaction: the squeezing of air out of the soil profile by foot and maintenance traffic.

Why I am banging on about this again?

Well hopefully your autumn and winter program is fully geared up to dealing with these two big issues.

By now I hope you have undertaken any major thatch removal work required and that you are now embarking on “an all winter long” attack on compaction.

Regular deep slit tining is the best way to relieve compaction; please note this is not a one off job regardless of how impressive the machine used.

It is necessary to continually slit tine the green through the winter to a depth of 150mm or deeper if you can.

Once a week isn’t too much, twice a month is more typical; stop during frost or excessively wet conditions but pick it up again as soon as possible afterwards.

For a full appraisal of essential winter maintenance tasks for your bowling green the Autumn/Winter report is still available at half price:

Bowls Green Maintenance and elephants

In the early part of the season no growth means no recovery from last winter’s damage, bare areas not filling in with new grass, bumps, hollows and all sorts of other problems mostly related to surface smoothness and consistency.

I’ve heard more than my fair share of strange reasons in bowling green maintenance circles when there is a lack of growth. These mostly centre on almost every bowling green maintenance practice except the one that matters…why?

Well the one that matters is “Irrigation” and it’s still a big taboo in a lot of clubs and in bowling green maintenance circles; it’s “the elephant in the room” to use one of the most annoying buzz phrases in recent times! However the elephant in the room description is a good one in this case; it’s this big, obvious thing in the room or in the conversation, but nobody mentions it!

One club I met with told me they have an “anti-watering brigade” in their club! Can you believe that, a group of members who are actively against watering the green regardless of how much it needs it?

On a well known bowling forum which shall remain nameless here, a contributor added his tuppence to the discussion on irrigation by “boasting” that they never water their green, as if it was some impressive badge to be worn. Another says that watering 3 times a day is crazy (as suggested by another contributor), even though he has no information to tell him the quantity of water being applied or thinking behind the plan.

We really must get over this folks or there will be a lot of very poor bowling green surfaces next year.